When a drain stops working properly, homeowners might want to contact plumbers in Ft Washington MD for help. Before they contact a plumber, however, they might want to check the drain trap. If they’re able to do this and clearing the trap fixes the problem, they might not have to contact a plumber for help. Clearing the drain trap only takes a few steps.
Look Under the Sink for Drain Trap and Remove
The drain trap should be a U-shaped piece underneath the sink. It should have a way to unscrew the pipe above and below the trap so it can be easily removed. Make sure there is no water in the sink before removing the trap and place a bucket under the trap to catch any leftover water. Then, unscrew the trap to remove it from under the sink.
Clean Out Drain Trap and Replace
If there is anything stuck in the drain trap, remove it and rinse the drain trap itself to make sure there’s nothing else left inside it. Once it’s clear, it’s possible to replace the drain trap and screw it back into place. Make sure the pipe is secured in place again, but do not over tighten as this can cause the pipe to crack. The pipe will need to be placed in the same way it was removed, but it should be simple to replace.
Check to See if Drain Works
The last step is to run water through the drain to make sure it drains properly. If the drain is still slow or the water doesn’t drain at all, the issue is likely farther down the pipes, past the drain trap. If that is the case, it’s necessary to contact a plumber for assistance. They can reach down further into the drain and clear any issues.
If you’ve tried checking the drain trap, but your drain is still not working properly, contact one of the Plumbers in Ft Washington MD for assistance. They’ll make sure the drain is cleared so you can start using it once again. Schedule an appointment to get the help you need today so you don’t have to worry about a drain that’s stopped up anymore.
